Subaru Crosstrek Service Manual: Wiring diagram
ENTERTAINMENT > Telematics System
WIRING DIAGRAM
Refer to “Telematics System” in the wiring diagram. Navigation System > WIRING DIAGRAM">
Inspection
ENTERTAINMENT > Telematics SystemINSPECTIONRefer to “Basic Diagnostic Procedure” in “TELEMATICS SYSTEM (DIAGNOSTICS)”. Basic Diagnostic Procedure"> ...
Note
ENTERTAINMENT > Telematics SystemNOTEFor procedure of each component in the telematics system, refer to the respective section.• Data communication module: Data Communication Module"> ...
Other materials:
Removal
STARTING/CHARGING SYSTEMS(H4DO) > GeneratorREMOVAL1. Remove the V-belt covers.2. Disconnect the ground cable from battery. NOTE">3. Remove the V-belts. V-belt > REMOVAL">4. Disconnect the connector (A) and terminal (B) from the generator, and remove the clip (C).5. Remove the ...
Inspection
CLUTCH SYSTEM > FlywheelINSPECTIONCAUTION:Because the center pilot bearing is grease-sealed and is a non-lubrication type, do not wash with gasoline or solvents.1. If there is damage or defectiveness in the facing sliding surface or ring gear, replace the flywheel.(A)Flywheel(B)Ring gear2. Smooth ...
Data link connector Note
ENGINE (DIAGNOSTICS)(H4DO) > Data Link ConnectorNOTEThis connector is used for Subaru Select Monitor.CAUTION:Do not connect any scan tools other than Subaru Select Monitor or general scan tool because the circuit may be damaged.Terminal No.ContentsTerminal No.Contents1Blank9Blank2Blank10Blank3Bla ...
