Subaru Crosstrek Owners Manual: Wheel replacement
When replacing wheels due, for example, to damage, make sure the replacement wheels match the specifications of the wheels that are fitted as standard equipment.
Replacement wheels are available from SUBARU dealers.
WARNING
Use only those wheels that are specified for your vehicle. Wheels not meeting specifications could interfere with brake caliper operation and may cause the tires to rub against the wheel well housing during turns. The resulting loss of vehicle control could lead to an accident.
NOTE
When any of the wheels are removed and replaced for tire rotation or for any other reason, always check the tightness of the wheel nuts after driving approximately 600 miles (1,000 km). If any nut is loose, tighten it to the specified torque.
Tire replacement
The wheels and tires are important and
integral parts of your vehicle's design;
they cannot be changed arbitrarily. The
tires fitted as standard equipment are
optimally matched to the characterist ...
Aluminum wheels
Aluminum wheels can be scratched and
damaged easily. Handle them carefully to
maintain their appearance, performance,
and safety.
When any of the wheels are removed
and replaced for tire rota ...
Other materials:
Dtc b2301 rear radar circuit high
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2301 REAR RADAR CIRCUIT HIGHDTC detecting condition:• Open circuit or short circuit to power supply in harness between radar sensor and outer mirror assembly.• Ope ...
Hill start assist system
Ensure that the Hill start assist system
operates properly under the following
circumstances.
1. Stop the vehicle on an uphill grade by
depressing the brake pedal (all models)
and clutch pedal (MT models only), with
the engine running.
2. Make sure that the vehicle does not
move backward ...
Removal
FRONT SUSPENSION > Front Ball JointREMOVAL1. Lift up the vehicle, and then remove the front wheels.2. Remove the under cover - front. Front Under Cover > REMOVAL">3. Remove the clamp - stabilizer bushing on the left and right sides.4. Remove the ball joint assembly.(1) Pull out the co ...
