Subaru Crosstrek Owners Manual: Triple meter screen
Triple meter screen (display example)
This screen displays up to three optional pieces of information that can be selected from the following items.
The items shown in the triple meter screen can be changed. For details, refer to "Triple meter setting"
| Item | Details |
 |
Average vehicle speed (Average vehicle speed for the entire driving time from when the trip meter was reset) |
 |
Lifetime fuel consumption |
 |
Engine oil temperature |
 |
Accelerator opening ratio |
 |
Journey time (the time that has elapsed since the ignition switch was turned to the "ON" position) (if equipped) |
 |
Journey distance (the distance that has been driven since the ignition switch was turned to the "ON" position) |
 |
Average fuel consumption for the entire driving distance from when the ignition switch was turned to the "ON" position |
 |
Boost pressure |
EyeSight screen (models with EyeSight system)
Current vehicle speed
Set vehicle speed
Preceding vehicle
Your vehicle
This screen displays the status of the
EyeSight system. For details, refer to the
Owner's Manual supplement for ...
Guidance screen
When the
button is pressed and held,
the selection screen can be displayed.
The displayed contents can be set or
customized from the selection screen. For
details, refer to "Selectio ...
Other materials:
Airbag warning light illumination pattern Inspection
AIRBAG SYSTEM (DIAGNOSTICS) > Airbag Warning Light Illumination PatternINSPECTIONTurn the ignition switch to ON, and confirm that the airbag warning light remains on for approx. 6 seconds then turns off afterwards.(1)Airbag warning light(2)Approx. 6 seconds(3)Ignition switch ON ...
Removal
FRONT SUSPENSION > Front CrossmemberREMOVALCAUTION:• The power steering control module continues to operate after the engine stops and calculate the temperature in the control module. Therefore, before starting service of the power steering system which requires disconnection of the connect ...
Installation
DRIVE SHAFT SYSTEM > Rear Drive ShaftINSTALLATION1. Replace the rear differential side oil seal. Rear Differential Side Oil Seal > REPLACEMENT">NOTE:After pulling out the drive shaft assembly, be sure to replace with a new oil seal.2. Insert the drive shaft assembly into the rear hub ...
