Subaru Crosstrek Service Manual: Removal

CAUTION:

Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">

1. Turn the ignition switch to OFF.

2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">

3. Remove the cover assembly - instrument panel LWR driver. Instrument Panel Lower Cover > REMOVAL">

4. Remove the nuts to remove the knee airbag module and disconnect the harness connector. Airbag Connector > PROCEDURE">

Installation

Passenger s airbag module

Other materials:

Dtc p0453 evap system (cpc) pressure sensor/switch circuit high
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0453 EVAP SYSTEM (CPC) PRESSURE SENSOR/SWITCH CIRCUIT HIGHDTC detecting condition:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mod ...

List of cancel code List
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > List of Cancel CodeLISTNOTE:• The cancel code is registered even when cancel is performed intentionally by the driver.• Cancel codes are cleared if the ignition switch is turned to OFF.• If a different cancel code is input after a cancel cod ...

Dtc c1411 electrical control module
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1411 ELECTRICAL CONTROL MODULEDTC detecting condition:Defective VDCCMTrouble symptom:• ABS does not operate.• EBD does not operate.• VDC does not operate.• Hill start ...