Subaru Crosstrek Service Manual: Removal
AIRBAG SYSTEM > Driver’s Airbag Module
REMOVAL
CAUTION:
Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">
1. Position the front wheels straight ahead.
2. Turn the ignition switch to OFF.
3. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
4. Remove the driver’s airbag module.
(1) Using a hexagon wrench etc. wrapped by protective tape, insert the snap pins and release the locks (three locations).
(2) Disconnect the horn harness and airbag connector, and remove the driver’s airbag module. Airbag Connector > PROCEDURE">
Installation
AIRBAG SYSTEM > Driver’s Airbag ModuleINSTALLATIONCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “A ...
Other materials:
Hazard warning flasher setting
1. Perform the preparation steps according
to "Preparation for car settings"
2. Operate the " " or "
" switch to
select the "Hazard Warning Flasher" item.Then push the button.
3. The current setting will be displayed.
Push the button to enter the
selection
mode.
4. Select "O ...
Braking
Braking tips
WARNING
Avoid keeping your foot resting on the brake pedal while driving the Subaru
Ascent. This can cause excessive heat buildup in the braking system and accelerate
wear of brake components, reducing braking efficiency.
When the brakes get wet
When driving the Subaru Ascent in ...
Dtc p0123 throttle/pedal position sensor/switch "a" circuit high
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0123 THROTTLE/PEDAL POSITION SENSOR/SWITCH "A" CIRCUIT HIGHDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Improper idling• Engine stall• Poor driving per ...
