Subaru Crosstrek Service Manual: Installation

CAUTION:

• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">

• Do not allow harness and connectors to interfere or get tangled up with other parts.

1. Before installation, inspect the following items and replace any faulty part with a new one.

• Airbag module is cracked or deformed.

• Harness and/or connector is cracked, deformed or open.

• Harness wire is exposed.

• The steering wheel is in the way, making it difficult to install the airbag module.

• The clearance between the driver’s airbag module and steering wheel is not constant.

2. Install the driver’s airbag module.

(1) Connect the airbag connector to the airbag module securely.

CAUTION:

• Be sure to insert the connector in until it is locked.

• Press in the push lock securely. Then pull it gently to make sure that it is locked.

(2) Connect the horn harness.

(3) Press in the locks (three positions) to install the airbag module.

CAUTION:

Make sure that the airbag module locks (three positions) are securely locked.

3. Install each part in the reverse order of removal.

CAUTION:

Make sure that the snap pin is set inside the guide.

Driver s airbag module

Removal

Other materials:

Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Forward Clutch AssemblyINSPECTION• Check the forward clutch drum, internal gear, sun gear and forward clutch piston lip for wear or damage.• Inspect the drive plate facing for wear and damage.• Check the driven plate for discoloration ...

Dtc u0416 invalid data received from vehicle dynamics control module
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0416 INVALID DATA RECEIVED FROM VEHICLE DYNAMICS CONTROL MODULEDTC DETECTING CONDITION:Data from VDCCM is faulty.TROUBLE SYMPTOM:ABS warning light and VDC warning light illuminate.STEPCHECKYESNO1.CHECK PERFORMI ...

Dtc u0401 invalid data received from ecm/pcm a
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0401 INVALID DATA RECEIVED FROM ECM/PCM “A”Detected when CAN data from ECM is abnormal.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE"> ...