Subaru Crosstrek Service Manual: Removal
WIPER AND WASHER SYSTEMS > Washer Tank and Motor
REMOVAL
1. WASHER TANK
1. Open the hood COMPL - front.
2. Disconnect the ground cable from battery. NOTE">
3. Remove the bumper face - front. Front Bumper > REMOVAL">
4. Remove the tank - washer assembly.
(1) Remove the clip of the holder - windshield washer tank.
(2) Disconnect the connector from the motor pump assembly - washer and the sensor - washer tank, and then remove the harness clip.
(3) Prepare a container before disconnecting the hose - washer, and drain all washer fluid in the tank - washer.
(4) Remove the bolt and nuts and remove the tank - washer assembly.
2. WASHER MOTOR
1. Open the hood COMPL - front.
2. Disconnect the ground cable from battery. NOTE">
3. Remove the screws and clips, turn over the mud guard - front LH, and disconnect the connector of the fog light assembly - front. (Model with fog light)
4. Disconnect the connector from the motor pump assembly - washer and remove the harness clip.
5. Prepare a container before disconnecting the hose - washer, and drain all washer fluid in the tank - washer.
6. Remove the motor pump assembly - washer from the tank - washer.
Inspection
WIPER AND WASHER SYSTEMS > Washer Tank and MotorINSPECTION1. WASHER PUMPApply battery voltage to the connector terminal of the motor pump assembly - washer, and make sure that the motor operates.2. ...
Installation
WIPER AND WASHER SYSTEMS > Washer Tank and MotorINSTALLATION1. Install each part in the reverse order of removal.CAUTION:• Install so that the front end of the under cover (b) comes inside th ...
Other materials:
Windows
WARNING
To prevent serious injury caused by entrapment in the Subaru Ascent, always
strictly follow the safety guidelines outlined below without exception.
When operating the Subaru Ascent power windows, exercise extreme caution
to ensure that no body parts, clothing, or foreign objects be ...
New vehicle break-in driving - the first 1,000 miles (1,600 km)
The performance and long life of your
vehicle are dependent on how you handle
and care for your vehicle while it is new.
Follow these instructions during the first
1,000 miles (1,600 km):
Do not race the engine. And do not
allow engine speed to exceed 4,000 rpm
except in an emergency
...
Specification
STARTING/CHARGING SYSTEMS(H4DO) > General DescriptionSPECIFICATIONItemSpecificationsVehicle modelCVTMTStarterTypeReduction typeModelM000T38571M000T33176ManufacturerMitsubishi ElectricVoltage and output12 V — 1.2 kW12 V — 1.0 kWDirection of rotationCounterclockwise (when observed from pinion)N ...
