Subaru Crosstrek Service Manual: Dtc b2779 remote control engine starter collation
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC B2779 REMOTE CONTROL ENGINE STARTER COLLATION
DTC detecting condition:
When the keyless access CM does not respond to engine start even when the remote control engine starter is ON, or when there is a code mismatch.
Trouble symptom:
Remote engine starter does not function.
| STEP | CHECK | YES | NO |
1.REGISTER THE REMOTE ENGINE STARTER.
1) Clear the DTC. Clear Memory Mode">
2) Register the remote engine starter using the Subaru Select Monitor. (Refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.)
NOTE:
When the registration failed, refer to “Correspondence table when registration is not possible” in “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.
3) Read the DTC again. Read Diagnostic Trouble Code (DTC)">
Is DTC B2779 displayed?
Replace the remote engine starter.
Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.
NOTE:
In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
Dtc b228a engine speed signal(with auto start stop)
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B228A ENGINE SPEED SIGNAL(WITH Auto Start Stop)DTC detecting condition:When t ...
Dtc b2781 steering lock cm control circuit
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2781 STEERING LOCK CM CONTROL CIRCUITDTC DETECTING CONDITION:• When ma ...
Other materials:
Inspection
BRAKE > Brake BoosterINSPECTION1. OPERATION CHECK WHEN NOT USING MEASURING DEVICESCAUTION:When checking operation, be sure to apply the parking brake securely.When an operation check is performed with no measuring devices, a faulty part cannot be identified correctly. But it is possible to identi ...
Removal
CLUTCH SYSTEM > Clutch PedalREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Turn the ignition switch to OFF.2. Disconnect the ground cable ...
Preparation tool
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subar ...
