Subaru Crosstrek Service Manual: Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Evaporator Sensor
REMOVAL
CAUTION:
Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">
1. Using the refrigerant recovery system, discharge refrigerant. Refrigerant Recovery Procedure > PROCEDURE">
2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
3. Remove the evaporator assembly - cooling. Evaporator > REMOVAL">
4. Remove the thermostat - cooling from the evaporator assembly - cooling.
Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Evaporator SensorINSPECTION1. MANUAL A/C MODELWIRING DIAGRAM:1. Prepare the vehicle.NOTE:Check that the ambient temperature is 25 — 40°C (77 ...
Installation
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Evaporator SensorINSTALLATIONCAUTION:• Make sure that the water seal packing on the cover attachment area is securely attached.• Replace the O ...
Other materials:
Synthetic oil
You should use synthetic engine oil that
meets the same requirements given for
conventional engine oil. When using
synthetic oil, you must use oil of the same
classification, viscosity and grade shown
in this Owner's Manual. Refer to "Engine
oil" F12-4. Also, you must follow the oil
and filte ...
Malfunction indicator light does not blink
ENGINE (DIAGNOSTICS)(H4DO) > Malfunction Indicator LightMALFUNCTION INDICATOR LIGHT DOES NOT BLINKDIAGNOSIS:• The malfunction indicator light circuit is open or shorted.• The delivery (test) mode fuse circuit is open.TROUBLE SYMPTOM:Malfunction indicator light does not blink during In ...
Preparation for date setting
Turn the ignition switch to the "ON"
position.
Push and hold the button to show
the selection screen.
After the selection screen is displayed,
operate the "
"
or "
" switch to show the
"Time/Date" item. Then, push the
button.
...
