Subaru Crosstrek Service Manual: Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Electronic Throttle Control Relay
REMOVAL
1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work.
2. Release the lock and remove the fuse holder from the relay & fuse box.
3. Disconnect the connectors from the relay & fuse box.
4. Remove the bolts (A) and nuts (B), and remove the relay & fuse box.
5. Remove the electronic throttle control relay from the relay block on the back side of the fuse block.
Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Electronic Throttle Control RelayINSPECTION1. Check that the electronic throttle control relay has no deformation, cracks or other damages.2. Measure the resis ...
Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Electronic Throttle Control RelayINSTALLATIONInstall in the reverse order of removal.Tightening torque:7.5 N·m (0.8 kgf-m, 5.5 ft-lb) ...
Other materials:
Electrical component location Location
ENGINE (DIAGNOSTICS)(H4DO) > Electrical Component LocationLOCATION1. CONTROL MODULE(1)Engine control module (ECM)(3)Malfunction indicator light(4)Data link connector(2)Delivery (test) mode fuse 2. SENSOR(1)Mass air flow and intake air temperature sensor(5)Crankshaft position sensor(9)Intake ca ...
Adjustment
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Main Shaft AssemblyADJUSTMENTSelection of main shaft rear plate:Measure the protrusion amount (A) of ball bearing from transmission main case surface, and select a suitable plate in the following table.NOTE:Before measuring, tap the end of main shaft wi ...
Note
EyeSight > Switches and HarnessNOTE1. PRE-COLLISION BRAKE OFF SWITCH & LANE DEPARTURE WARNING OFF SWITCHThe pre-collision brake OFF & lane departure warning OFF switch is integrated in the stereo camera cover assembly.If the pre-collision brake OFF & lane departure warning OFF switch ...
