Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Installation

FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Electronic Throttle Control Relay

INSTALLATION

Install in the reverse order of removal.

Tightening torque:

7.5 N·m (0.8 kgf-m, 5.5 ft-lb)

Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Electronic Throttle Control RelayREMOVAL1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work.2. Release the lock a ...

Engine control module (ecm)
...

Other materials:

Dtc p0341 camshaft position sensor "a" circuit range/performance bank 1 or single sensor
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0341 CAMSHAFT POSITION SENSOR "A" CIRCUIT RANGE/PERFORMANCE BANK 1 OR SINGLE SENSORNOTE:For the diagnostic procedure, refer to DTC P0340. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > ...

Inspection
CONTROL SYSTEMS > Select CableINSPECTIONCheck the removed cable and replace or adjust if damaged, rusty or malfunctioning.1. Check the cable for smooth operation.2. Check the inner cable for damage and rust.3. Check the outer cable for damage, bends and cracks.4. Check the boot for damage, cracks ...

Rear tie-down holes
Rear tie-down hole The rear tie-down holes are located near each of the jack-up reinforcements. There is a plug in each rear tie-down hole. To use the rear tie-down holes, remove the plugs. After using the rear tie-down holes, return the plugs to their original places. WARNING ...

© 2016-2026 Copyright www.sucross.com