Subaru Crosstrek Owners Manual: Parking brake
To set the parking brake, depress the brake pedal firmly and hold it down until the parking brake lever is fully pulled up.
To release the parking brake, pull the lever up slightly, press the release button, then lower the lever while keeping the button pressed.
When the parking brake is set while the engine is running, the parking brake warning light illuminates. After starting the vehicle, be sure that the warning light has turned off before the vehicle is driven.
Refer to "Brake system warning light (red)" F3-21.
CAUTION
Never drive while the parking brake is set because this will cause unnecessary wear on the brake linings.
Before starting to drive, always make sure that the parking brake has been fully released.
Parking tips
When parking your vehicle, always perform
the following items.
Apply the parking brake firmly
For MT models, put the shift lever in the
"1" (1st) for upgrade or "R" (Reverse) for a
downgrad ...
Other materials:
Removal
ENTERTAINMENT > AntennaREMOVAL1. RADIO/TELEMATICS ANTENNACAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Disconnect the ground cable from battery ...
Specification
VEHICLE DYNAMICS CONTROL (VDC) > General DescriptionSPECIFICATIONItemSpecification or identificationABS wheel speed sensorABS wheel speed sensor gap (for reference)Front0.77 — 1.43 mm (0.030 — 0.056 in)Rear0.44 — 1.76 mm (0.017 — 0.069 in)Identifications of harness (symbol)FrontRHZ1LHZ2Re ...
Installation
REAR SUSPENSION > Rear Trailing LinkINSTALLATIONCAUTION:• Be sure to use a new self-locking nut.• Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.1. Install each part in the reverse order of removal.Tighten ...
