Subaru Crosstrek Service Manual: Installation

CAUTION:

• Be sure to use a new self-locking nut.

• Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.

1. Install each part in the reverse order of removal.

Tightening torque:

Refer to “COMPONENT” of “General Description”. General Description > COMPONENT">

2. Install the rear wheels.

Tightening torque:

Except for C4 model: 120 N·m (12.24 kgf-m, 88.5 ft-lb)

C4 model: 100 N·m (10.20 kgf-m, 73.8 ft-lb)

Disassembly

Upper arm

Other materials:

Location
EyeSight > Relay and FuseLOCATIONRelay & fuse boxFuse 10 A (stop light and brake switch, brake light relay)(A)Relay holderBrake light relay(B)NOTE:For other related fuses, refer to the wiring diagram. Power Supply Circuit"> ...

Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Crankshaft Position Sensor PlateREMOVALThe crankshaft position sensor plate is tightened together with the drive plate or flywheel; therefore, refer to “Drive Plate” or “Flywheel” for removal procedure. Drive Plate > REMOVAL"& ...

Brake fluid
Checking the fluid level WARNING Never let brake fluid contact your eyes because brake fluid can be harmful to your eyes. If brake fluid gets in your eyes, immediately flush them thoroughly with clean water. For safety, when performing this work, wearing eye protection is advisabl ...