Subaru Crosstrek Service Manual: Removal
EXHAUST(H4DO) > Muffler
REMOVAL
CAUTION:
Vehicle components are extremely hot after driving. Be wary of receiving burns from heated parts.
1. Turn the ignition switch to OFF.
2. Lift up the vehicle.
3. Remove the bolts and self-locking nuts which secure the rear exhaust pipe to the muffler.
4. Apply a coat of spray type lubricant to the mating area of cushion rubber.
5. Remove the muffler from the cushion rubber.
CAUTION:
Be careful not to drop the muffler during removal.
6. Remove the heat shield cover from the vehicle.
Inspection
EXHAUST(H4DO) > MufflerINSPECTION1. Check the connections and welded parts for exhaust leaks.2. Make sure there are no holes or rusting.3. Check the cushion rubber for wear or crack. ...
Installation
EXHAUST(H4DO) > MufflerINSTALLATIONInstall in the reverse order of removal.NOTE:• Use a new gasket and self-locking nut.• After assembling, degrease the lubricant which was applied to t ...
Other materials:
Vehicle Dynamics Control warning light/ Vehicle Dynamics Control operation indicator
light
Vehicle Dynamics Control warning light
CAUTION
In the Subaru Ascent, the Vehicle Dynamics Control (VDC) system relies on
the ABS through a shared electrical circuit. If the ABS system becomes inoperative
for any reason, the VDC system will also lose its ability to provide ABS-related
control ...
Dtc b28a3 eyesight communication(meter)
EyeSight (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B28A3 EyeSight COMMUNICATION(METER)Detected when the combination meter detects the malfunction of stereo camera.DTC DETECTING CONDITION:• Defective CAN system• Defective combination meter• Defect ...
Activating and deactivating the alarm system
To change the setting of your vehicle's
alarm system for activation or deactivation,
do the following.
1. Disarm the alarm system. Refer to
"Disarming the system" 2-30.
2. Sit in the driver's seat and shut all
doors and the rear gate.
3. Turn the ignition switch to the "ON"
position.
...
