Subaru Crosstrek Service Manual: Installation
EXHAUST(H4DO) > Muffler
INSTALLATION
Install in the reverse order of removal.
NOTE:
• Use a new gasket and self-locking nut.
• After assembling, degrease the lubricant which was applied to the cushion rubber while removing/installing.
Tightening torque:
10 N·m (1.0 kgf-m, 7.4 ft-lb)
Tightening torque:
48 N·m (4.9 kgf-m, 35.4 ft-lb)
Removal
EXHAUST(H4DO) > MufflerREMOVALCAUTION:Vehicle components are extremely hot after driving. Be wary of receiving burns from heated parts.1. Turn the ignition switch to OFF.2. Lift up the vehicle.3. R ...
Other materials:
Dtc b1830 short in curtain airbag rh squib circuit
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1830 SHORT IN CURTAIN AIRBAG RH SQUIB CIRCUITDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Curtain airbag harness (RH) circuit is shorted.• Curtain airbag module (RH) is faulty. ...
Installation
DRIVE SHAFT SYSTEM > Rear Hub Unit BearingINSTALLATION1. Place the rear brake back plate between the rear axle housing and the rear hub unit bearing, and tighten the bolt.CAUTION:• Be careful not to damage the magnetic encoder.• Do not get closer the tool which charged magnetism to ma ...
Check power supply and ground line of engine control module (ecm)
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostics for Engine Starting FailureCHECK POWER SUPPLY AND GROUND LINE OF ENGINE CONTROL MODULE (ECM)CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION">, and Inspection Mode Inspection Mode > ...
