Subaru Crosstrek Service Manual: Operation
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Read Current Data
OPERATION
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «Subaru Rear Vehicle Detection(RH)» or «Subaru Rear Vehicle Detection(LH)» and then select «Enter».
5. On «Select Function» display, select «Data Monitor».
NOTE:
For detailed operation procedures, refer to “Application help”.
List
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Read Current DataLIST• «Subaru Rear Vehicle Detection (LH)»DisplayContentReference valueNoteSRVD System fail flagCurrent failur ...
Other materials:
Dtc p2270 o2 sensor signal biased/stuck lean bank 1 sensor 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2270 O2 SENSOR SIGNAL BIASED/STUCK LEAN BANK 1 SENSOR 2DTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Me ...
Installation
EXTERIOR/INTERIOR TRIM > Roof MoldingINSTALLATION1. Remove the clips from the molding - roof, and attach to the studs on the vehicle.CAUTION:• Always replace the clips that were damaged during removal of the molding - roof with new parts.• While installing the molding - roof, be caref ...
Rear combination lights
1. Using a Phillips screwdriver, remove
the upper and lower screws that secure
the rear combination light assembly.
2. Slide the rear combination light as-
11-38
sembly rearward and remove it from the
vehicle.
Rear side marker light
Rear turn signal light
Backup light
Sto ...
