Subaru Crosstrek Service Manual: Subaru select monitor

Subaru Crosstrek Service Manual / Blind spot detection/rear cross traffic alert (diagnostics) / Subaru select monitor

Operation

Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Read Current DataOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle i ...

Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Subaru Select MonitorINSPECTION1. COMMUNICATION FOR INITIALIZING IMPOSSIBLEWhen communication with the radar sensor is impossibleDetect ...

Other materials:

Inspection
BRAKE > Front Brake PadINSPECTION1. Check the pad thickness (A).NOTE:• Always replace the pads of both wheels and both sides as a set.• Replace pad clips if they are twisted or worn.• Replace the pad if there is oil or grease on it. Standard (A)Wear limit (B)Pad thickness11 mm ( ...

Dtc u0073 control module communication bus off
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0073 CONTROL MODULE COMMUNICATION BUS OFFNOTE:For the diagnostic procedure, refer to LAN section. Basic Diagnostic Procedure">1. OUTLINE OF DIAGNOSISDetect malfunction of CAN communication.Judge as N ...

Removal
GLASS/WINDOWS/MIRRORS > Rear Gate GlassREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the roof spoiler. (Crosstrek model) Roof Spoiler > REMOVAL">3. Remove the trim panel - rear gate and the motor assembly - rear wiper. Rear Wiper Motor > REMOVAL" ...