Subaru Crosstrek Service Manual: Rear exhaust pipe

Installation

EXHAUST(H4DO) > MufflerINSTALLATIONInstall in the reverse order of removal.NOTE:• Use a new gasket and self-locking nut.• After assembling, degrease the lubricant which was applied to t ...

Inspection

EXHAUST(H4DO) > Rear Exhaust PipeINSPECTION1. Check the connections and welded parts for exhaust leaks.2. Make sure there are no holes or rusting.3. Check the cushion rubber for wear or crack. ...

Other materials:

Installation
STARTING/CHARGING SYSTEMS(H4DO) > BatteryINSTALLATIONCAUTION:After the battery is installed, initial diagnosis of the electronic throttle control is performed. Wait for 10 seconds or more after turning the ignition switch to ON, and then start the engine.1. Install the battery.2. Set the battery ...

Hazard warning flasher setting
1. Perform the preparation steps according to "Preparation for car settings" 2. Operate the " " or " " switch to select the "Hazard Warning Flasher" item.Then push the button. 3. The current setting will be displayed. Push the button to enter the selection mode. 4. Select "O ...

Inspection
ENGINE (DIAGNOSTICS)(H4DO) > General DescriptionINSPECTIONBefore performing diagnostics, check the following item which might affect engine problems.1. BATTERY1. Check the battery. Battery > INSPECTION">2. Check the condition of the main and other fuses, and harnesses and connectors. ...