Subaru Crosstrek Service Manual: Installation
EXHAUST(H4DO) > Rear Exhaust Pipe
INSTALLATION
1. Apply a coat of spray type lubricant to the mating area of cushion rubber.
2. Install the rear exhaust pipe to cushion rubber.
NOTE:
After assembling, degrease the lubricant which was applied to the cushion rubber while removing/installing.
3. Install the bolts and self-locking nuts which secure the muffler to the rear exhaust pipe.
NOTE:
Use a new gasket and self-locking nut.
Tightening torque:
48 N·m (4.9 kgf-m, 35.4 ft-lb)
4. Install the bolts, springs, and nuts which secure the center exhaust pipe to the rear exhaust pipe.
NOTE:
Use a new gasket.
Tightening torque:
18 N·m (1.8 kgf-m, 13.3 ft-lb)
5. Lower the vehicle.
Removal
EXHAUST(H4DO) > Rear Exhaust PipeREMOVALCAUTION:Vehicle components are extremely hot after driving. Be wary of receiving burns from heated parts.1. Turn the ignition switch to OFF.2. Lift up the ve ...
Other materials:
Removal
DRIVE SHAFT SYSTEM > Rear Drive ShaftREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle, and then remove the rear wheels.3. Remove the axle nut.CAUTION:Do not loosen the axle nut while the rear axle is loaded. Doing so may damage the hub unit bearing.(1) Lif ...
Preparation tool
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Select Mo ...
Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Refrigerant Pressure with Manifold Gauge SetINSPECTION1. INSPECTION WITH PRESSURE SYMPTOMSSymptomsReferenceBoth high and low pressure sides are low. Refrigerant Pressure with Manifold Gauge Set > INSPECTION">Both high and low pressure sides ar ...
