Subaru Crosstrek Service Manual: Dtc b28a3 eyesight communication(meter)

Detected when the combination meter detects the malfunction of stereo camera.

DTC DETECTING CONDITION:

• Defective CAN system

• Defective combination meter

• Defective stereo camera

• All functions of EyeSight system do not operate.

• EyeSight warning light illuminates.

1.CHECK LAN SYSTEM.

Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE">

Is the DTC displayed in the LAN system?

Perform the diagnosis according to DTC.

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B28A3 EyeSight COMMUNICATION(METER)">Go to Step 2.

2.CHECK COMBINATION METER.

Check the combination meter. Basic Diagnostic Procedure > PROCEDURE">

Is combination meter OK?

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B28A3 EyeSight COMMUNICATION(METER)">Go to Step 3.

Perform the diagnosis for combination meter.

3.CHECK CONNECTOR.

Check the combination meter connector and the stereo camera connector.

Is the connector OK?

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B28A3 EyeSight COMMUNICATION(METER)">Go to Step 4.

Repair or replace the connector.

4.CHECK STEREO CAMERA.

Read the DTC. Diagnostic Code(s) Display">

Is another DTC displayed?

Perform the diagnosis according to DTC.

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B28A3 EyeSight COMMUNICATION(METER)">Go to Step 5.

5.CHECK STEREO CAMERA.

1) Clear the memory. Clear Memory Mode">

2) Read the DTC. Diagnostic Code(s) Display">

Is the same DTC displayed?

Replace the stereo camera. Stereo Camera > REMOVAL">

Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

NOTE:

In this case, temporary poor contact of connector, or temporary open or short circuit of harness may be the cause.

Dtc b28a2 eyesight communication(vdc)

Dtc b28a5 engine torque limiter control prohibit

Other materials:

Dtc b1623 side airbag sensor rh initialization error
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1623 SIDE AIRBAG SENSOR RH INITIALIZATION ERRORDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Open or short circuit in harness of side sensor bus (RH)• Side airbag sensor (RH) an ...

Removal
EXTERIOR BODY PANELS > Rear Sealing CoverREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear door. Door Trim > REMOVAL">3. Remove the sealing cover - rear door.CAUTION:• Carefully remove the butyl tape. Excessive force will easily b ...

Removal
MECHANICAL(H4DO) > Engine AssemblyREMOVAL1. Open the front hood, and make alignment marks (A) on both the front hood and the front hood striker by using a marker pen.2. Remove the front hood striker from the front hood.3. Change the front hood stay position from (A) to (B), and completely open th ...