Subaru Crosstrek Service Manual: Removal

Subaru Crosstrek Service Manual / Entertainment / Switches and harness / Removal

ENTERTAINMENT > Switches and Harness

REMOVAL

1. SATELLITE SWITCH ASSEMBLY

CAUTION:

Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">

1. Set the tire to the straight-ahead position.

2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">

3. Remove the driver’s airbag module. Driver’s Airbag Module > REMOVAL">

4. Remove the steering wheel. Steering Wheel > REMOVAL">

5. Remove the satellite switch assembly. Steering Wheel > DISASSEMBLY">

2. TELEMATICS BUTTON

The telematics button is a single unit with the spot map light or stereo camera cover assembly. For operation procedures, refer to “LIGHTING SYSTEM” section. Spot Map Light > REMOVAL">

Inspection

ENTERTAINMENT > Switches and HarnessINSPECTION1. SATELLITE SWITCH ASSEMBLY1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStand ...

Installation

ENTERTAINMENT > Switches and HarnessINSTALLATION1. SATELLITE SWITCH ASSEMBLYCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Descriptio ...

Other materials:

Dtc c2221 transmitter 1 pressure data abnormal
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C2221 TRANSMITTER 1 PRESSURE DATA ABNORMALNOTE:Refer to DTC C2224 for diagnostic procedure. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C2224 TRANSMITTER 4 PRESSURE DAT ...

Dtc c1251 wheel speed sensor system
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1251 WHEEL SPEED SENSOR SYSTEMNOTE:For the diagnostic procedure, refer to “DTC C1241 REAR LEFT ABS SENSOR CIRCUIT”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > ...

Bypass screen setting
1. Perform the preparation steps according to "Preparation for screen settings" 2. Operate the " " or " " switch to select the "Bypass Screen" item. Then push the button. 3. Select the item to set by operating the " " or " " switches. Then push the button ...