Subaru Crosstrek Service Manual: Installation
ENTERTAINMENT > Switches and Harness
INSTALLATION
1. SATELLITE SWITCH ASSEMBLY
CAUTION:
• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">
• Do not allow harness and connectors to interfere or get tangled up with other parts.
• If the steering wheel has been removed, make sure that the steering roll connector is not turned from the original position.
• If the steering wheel and steering angle sensor (steering roll connector) are removed, perform “VSC(VDC) Centering Mode” of the VDC. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT">
• Securely install the switch. Improper insertion of the pin or claw of the switch may cause improper installation.
1. Align the center position of the steering roll connector. Roll Connector > ADJUSTMENT">
2. Install each part in the reverse order of removal.
NOTE:
Align the alignment marks on the steering wheel and the column assembly - steering.
Tightening torque:
Steering wheel: 39 N·m (3.98 kgf-m, 28.8 ft-lb)
Clearance:
Between cover assembly - column and steering wheel: 4 — 6 mm (0.16 — 0.24 in)
2. TELEMATICS BUTTON
The telematics button is a single unit with the spot map light or stereo camera cover assembly. For operation procedures, refer to “LIGHTING SYSTEM” section. Spot Map Light > INSTALLATION">
Removal
ENTERTAINMENT > Switches and HarnessREMOVAL1. SATELLITE SWITCH ASSEMBLYCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in & ...
Other materials:
Handling of radar sensors
Sensors
In the Subaru Ascent, radar sensors are strategically positioned on both sides
of the rear bumper to monitor adjacent traffic and support BSD/RCTA functionality.
To maintain reliable and accurate operation of the Subaru Ascent BSD/RCTA system,
the following precautions must al ...
Inspection
DIFFERENTIALS > Rear Differential (VA-type)INSPECTIONWash all the disassembled parts clean, and examine them for wear, damage or other defects. Repair or replace the defective parts as necessary.1. Hypoid driven gear and drive pinion• If there is evidently an abnormal tooth contact, find ou ...
Caution
BODY CONTROL SYSTEM (DIAGNOSTICS) > General DescriptionCAUTION1. SRS AIRBAG SYSTEMAirbag system wiring harness is routed near the body integrated unit and body control circuits.CAUTION:• Do not use the electrical test equipment on all airbag system wiring harnesses and connectors.• Be ...
