Subaru Crosstrek Service Manual: Removal
CLUTCH SYSTEM > Clutch Disc and Cover
REMOVAL
1. Remove the transmission assembly from the vehicle.
Manual Transmission Assembly > REMOVAL">
2. Attach the ST on the flywheel.
| ST 499747100 | CLUTCH DISC GUIDE |
3. Remove the clutch cover and clutch disc.
NOTE:
• Take care not to allow oil to touch the clutch disc face.
• Do not disassemble the clutch cover or clutch disc.
Inspection
CLUTCH SYSTEM > Clutch Disc and CoverINSPECTION1. CLUTCH DISC1. Facing wearMeasure the depth from the facing surface to the rivet head. Replace if the face is worn locally or worn down to less than ...
Installation
CLUTCH SYSTEM > Clutch Disc and CoverINSTALLATION1. Insert the ST into the clutch disc and the ST end into pilot bearing to install the clutch disc.NOTE:When installing the clutch disc, be careful ...
Other materials:
Adjustment
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Idler GearADJUSTMENT1. Select the appropriate reverse shifter lever from the table below, and adjust until the clearance between the reverse idler gear and transmission case wall is within specification.Clearance A:6.0 — 7.5 mm (0.236 — 0.29 ...
Installation
EXTERIOR/INTERIOR TRIM > Roof SpoilerINSTALLATIONCAUTION:• Make sure that packings are attached on the clips of the roof spoiler assembly. If a gasket is not attached, water leakage may occur.• Make sure the bolt is tightened securely because improper installation may cause the water ...
Top display setting
1. Perform the preparation steps according
to "Preparation for screen settings"
2. Operate the "
"
or "
" switch to
select the "Top Display" item. Then push
the
button.
3. Push the
button once more.
4. Select an item by operating the "
" or
"
" switc ...
