Subaru Crosstrek Service Manual: Relay and fuse

Operation

INSTRUMENTATION/DRIVER INFO > Multi-function Display (MFD) SystemOPERATION1. DIAGNOSTIC MODE (HIGH GRADE TYPE ONLY)The settings of the multi-function display can be changed by performing the follow ...

Inspection

INSTRUMENTATION/DRIVER INFO > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.NOTE:If the fuse is blown again, check the s ...

Other materials:

Assembly
DRIVE SHAFT SYSTEM > Rear Drive ShaftASSEMBLYCAUTION:Wrap shaft splines with vinyl tape to protect the boot from scratches.NOTE:Use specified grease.Grease:BJ, EBJ side: NKG814DOJ side: NKG8141. Install the inner race to the shaft.(1) Install the boot (BJ) or boot (EBJ) in the specified position, ...

Instrument panel wiring harness Location
WIRING SYSTEM > Instrument Panel Wiring HarnessLOCATIONConnectorConnecting toNo.PoleColorAreaNo.Descriptioni210D-1R339Rear wiring harness LHi520C-1 F/Bi74GrayB-4 MFD switchi1040B-3 Combination meteri156C-4 Blower fan switch (manual A/C)i1616B-4 A/C control panel (manual A/C)i224B-4 Hazard switchi ...

Dtc p0072 ambient air temperature sensor circuit "a" low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0072 AMBIENT AIR TEMPERATURE SENSOR CIRCUIT "A" LOWDTC detecting condition:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory ...