Subaru Crosstrek Service Manual: Inspection
INSTRUMENTATION/DRIVER INFO > Relay and Fuse
INSPECTION
1. CHECK FUSE
1. Remove the fuse and inspect visually.
2. If the fuse is blown out, replace the fuse.
NOTE:
If the fuse is blown again, check the system wiring harness.
Relay and fuse
...
Location
INSTRUMENTATION/DRIVER INFO > Relay and FuseLOCATIONRelay & fuse boxFuse 10 A (combination meter, MFD)(A)NOTE:For other related fuses, refer to the wiring diagram. Power Supply Circuit"&g ...
Other materials:
Active test Operation
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Active TestOPERATIONCAUTION:• Be sure to perform the active test while the engine is not running.• After executing the active test, execute the Clear Memory Mode.1. On «Start» display, select «Diagnosis».2. On «Vehicle selection ...
Cup holders
CAUTION
Do not pick up a cup from the cup
holder or put a cup in the holder
while you are driving, as this may
distract you and lead to an
accident.
Take care to avoid spills. Beverages,
if hot, might scald you
and/or your passengers. Spilled
beverages may also damage upholstery
...
Dtc p013f o2 sensor delayed response - lean to rich bank 1 sensor 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P013F O2 SENSOR DELAYED RESPONSE - LEAN TO RICH BANK 1 SENSOR 2NOTE:For the diagnostic procedure, refer to DTC P013A. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P013A O2 SENSOR SLOW RESP ...
