Subaru Crosstrek Service Manual: Clear memory mode Operation

1. On «Start» display, select «Diagnosis».

2. On «Vehicle selection» display, input the vehicle information and select «Confirmed».

3. On «Main Menu» display, select «Each System».

4. On «Select System» display, select «Transmission Control System».

5. On «Select Function» display, select «DTC».

6. On «DTC» display, select «Clear Memory».

NOTE:

For detailed operation procedures, refer to “Application help”.

Check list for interview Check

Diagnostic procedure for subaru select monitor communication Communication for initializing impossible

Other materials:

Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Forward Clutch AssemblyINSPECTION• Check the forward clutch drum, internal gear, sun gear and forward clutch piston lip for wear or damage.• Inspect the drive plate facing for wear and damage.• Check the driven plate for discoloration ...

Assembly
DRIVE SHAFT SYSTEM > Front Drive ShaftASSEMBLY1. Roll up a thick piece of paper to a size where the shaft can pass through, and affix with tape to form a cylinder.2. Attach a new O-ring on this cylinder.CAUTION:• Always use a new O-ring.• Be careful that the O-ring does not become scr ...

Reverse function
WARNING Keep all body parts clear when operating the Subaru Ascent reverse function. If the system fails to react properly, serious injury may occur. The Subaru Ascent reverse function may not activate if an object is trapped just before the rear gate fully closes. Always exercise cautio ...