Subaru Crosstrek Service Manual: Reduction drive gear

Installation

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Primary Speed SensorINSTALLATIONCAUTION:Be sure to prevent water or oil from contacting the connector terminal of primary speed sensor. If adhesion occur ...

Adjustment

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Reduction Drive GearADJUSTMENT1. Remove the retaining springs and reduction drive gear shims.2. Install the transmission case, and secure it with four or ...

Other materials:

Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel Level SensorREMOVALWARNING:Place “NO OPEN FLAMES” signs near the working area.CAUTION:• Be careful not to spill fuel.• If the fuel gauge indicates that two thirds or more of the fuel is remaining, be sure to drain fuel before star ...

Malfunction indicator light does not come on
ENGINE (DIAGNOSTICS)(H4DO) > Malfunction Indicator LightMALFUNCTION INDICATOR LIGHT DOES NOT COME ONTROUBLE SYMPTOM:When the ignition switch is turned to ON (engine OFF), malfunction indicator light does not illuminate.NOTE:Refer to IDI section for diagnostic procedure. Basic Diagnostic Procedur ...

Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Blower Resistor (Manual A/C Model)INSPECTION1. Check the resistance between resistor terminals.Preparation tool:Circuit testerTerminal No.StandardConnection diagram4 — 3Approx. 0.43 ?4 — 2Approx. 1.03 ?4 — 1Approx. 3 ?2. Replace the resistor if the ...