Subaru Crosstrek Service Manual: Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Primary Speed Sensor
INSTALLATION
CAUTION:
Be sure to prevent water or oil from contacting the connector terminal of primary speed sensor. If adhesion occurs, replace with a new part.
Install in the reverse order of removal.
NOTE:
• Use new O-rings.
• Apply CVTF to the O-ring.
Tightening torque:
7 N·m (0.7 kgf-m, 5.2 ft-lb)
Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Primary Speed SensorREMOVALCAUTION:Be sure to prevent water or oil from contacting the connector terminal of primary speed sensor. If adhesion occurs, re ...
Other materials:
General precautions when starting/stopping engine
WARNING
Never start the engine from outside
the vehicle (except when
using the remote engine start
system). It may result in an
accident.
Do not leave the engine running
in locations with poor ventilation,
such as a garage and indoors.
The exhaust gas may enter the
vehicle or i ...
Keyless buzzer volume setting
1. Perform the preparation steps according
to "Preparation for car settings"
2. Operate the " " or "
" switch to
select the "Keyless Buzzer Volume" item.
Then push the button.
3. Select a volume level by operating the
" " or "
" switch, and confirm the set ...
Rear center seatbelt
Center seatbelt tongue plate
Connector (tongue)
Connector (buckle)
Center seatbelt buckle
WARNING
Fastening the seatbelt with the webbing
twisted can increase the risk or
severity of injury in an accident.
When fastening the belt after it is
pulled out from the retractor, ...
