Subaru Crosstrek Service Manual: Installation

1. Install the reduction drive gear to secondary pulley.

2. Select the reduction drive gear shim. Reduction Drive Gear > ADJUSTMENT">

3. Install the dish plates, spring retainers, and selected reduction drive gear shims.

NOTE:

Install the dish plate in the correct direction.

4. Install the transmission case. Transmission Case > INSTALLATION">

5. Install the transmission control device. Transmission Control Device > INSTALLATION">

6. Install the oil strainer and oil pan. Oil Pan and Strainer > INSTALLATION">

7. Install the reduction driven gear assembly. Reduction Driven Gear > INSTALLATION">

8. Install the parking pawl. Parking Pawl > INSTALLATION">

9. Install the transfer driven gear assembly. Transfer Driven Gear > INSTALLATION">

10. Install the transfer clutch assembly. Transfer Clutch > INSTALLATION">

11. Install the extension case. Extension Case > INSTALLATION">

12. Install the inhibitor switch. Inhibitor Switch > INSTALLATION">

13. Install the secondary speed sensor. Secondary Speed Sensor > INSTALLATION">

14. Install the primary speed sensor. Primary Speed Sensor > INSTALLATION">

15. Install the turbine speed sensor. Turbine Speed Sensor > INSTALLATION">

16. Install the transmission harness. Transmission Harness > INSTALLATION">

17. Install the control valve body. Control Valve Body > INSTALLATION">

18. Install the air breather hose. Air Breather Hose > INSTALLATION">

19. Install the transmission assembly to the vehicle. Automatic Transmission Assembly > INSTALLATION">

Inspection

Reduction driven gear

Other materials:

Component
SPEED CONTROL SYSTEMS(H4DO) > General DescriptionCOMPONENT(1)Accelerator pedal ASSY (sport type)(4)Accelerator plateTightening torque: N·m (kgf-m, ft-lb)(2)Accelerator pedal ASSY (normal type)(5)Accelerator stopperT:7.5 (0.8, 5.5)(3)Clip ...

Welcome screen and Good-bye screen
When the driver's door is opened and closed after unlocking the door, the welcome screen will appear on the multi information display for approximately 20 seconds. When the ignition switch is turned to the "LOCK"/"OFF" position, the multi information display gradually turns off (Good-bye s ...

Installation
EXHAUST(H4DO) > Front Exhaust PipeINSTALLATION1. Set the front exhaust pip and center exhaust pipe to the vehicle, and temporally tighten the nuts which secure the front exhaust pipe to cylinder head.NOTE:Use a new gasket.2. Install the bolts, springs, and nuts which secure the rear exhaust pipe ...