Subaru Crosstrek Service Manual: Read cancel code Operation

1. On «Start» display, select «Diagnosis».

2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».

3. On «Main Menu» display, select «Each System».

4. On «Select System» display, select «Subaru Rear Vehicle Detection(RH)» or «Subaru Rear Vehicle Detection(LH)» and then select «Enter».

5. On «Select Function» display, select «Cancel Code».

NOTE:

• For detailed operation procedures, refer to “Application help”.

• For details concerning cancel codes, refer to the List of Cancel Codes. List of Cancel Code">

List of diagnostic trouble code (dtc) List

Read diagnostic trouble code (dtc) Operation

Other materials:

Removal
LIGHTING SYSTEM > Rear Turn Signal Light BulbREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be careful not to damage the clips.(1) Release the bolts and clips, then pull out the light assembly - rear com ...

Diagnostics with phenomenon Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Diagnostics with PhenomenonINSPECTIONSymptomsFaulty partsStall speed is low after warming-up, with select lever in “D” or “R” range.Engine control systemVehicle does not move despite engine speed rising up, with select lever in & ...

Selecting an audio source
1. Press the AUDIO/TUNE knob. 2. Select the desired source. Example: Source select screen NOTE If the audio control screen appears, select the "Source" key on the audio screen or press the AUDIO/TUNE knob again. When you push the AUDIO/TUNE knob while any screen other than t ...