COOLING(H4DO) > Radiator Cap
INSPECTION
1. Check that the radiator cap does not have deformation, cracks or damage.
2. Attach the radiator cap tester to radiator cap.

3. Increase pressure until the radiator cap tester gauge needle stops. Radiator cap is functioning properly if it holds the service limit pressure for 5 — 6 seconds. Replace the radiator cap if its valve opens at less than the service limit.
CAUTION:
Be sure to remove foreign matter and rust from the cap in advance. Otherwise, results of pressure test will be incorrect.
Standard:
93 — 123 kPa (0.95 — 1.25 kg/cm2, 14 — 18 psi)
Service limit:
83 kPa (0.85 kg/cm2, 12 psi)
Engine cooling system trouble in general InspectionSteering switches for audio
Some parts of the audio/visual system can
be adjusted using the switches on the
steering wheel.
+ − switch
switch
Mute/Enter switch
List switch
Back switch
Source switch
+/− switch
Mode
Operation
Function
Except list screen
Press
V ...
Dtc b1571 reference code incompatibility (immobilizer cm to ecm)
IMMOBILIZER (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1571 REFERENCE CODE INCOMPATIBILITY (IMMOBILIZER CM TO ECM)DTC DETECTING CONDITION:Reference code incompatibility between body integrated unit and ECMCAUTION:When the body integrated unit is replaced, registra ...
Dtc b19f3 short in front p/t 2 rh (to +b)
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B19F3 SHORT IN FRONT P/T 2 RH (TO +B)Diagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Lap seat belt pretensioner (RH) circuit is shorted to power supply.• Lap seat belt pretensioner ...