Subaru Crosstrek Service Manual: Preparation tool
FRONT SUSPENSION > General Description
PREPARATION TOOL
1. SPECIAL TOOL
ILLUSTRATION | TOOL NUMBER | DESCRIPTION | REMARKS |
927680000
INSTALLER & REMOVER SET
Used for replacing the bushing front - front arm of front arm assembly.
20299AG000
REMOVER
• Used for replacing the bushing rear - front arm of front arm assembly.
• Used together with BASE (20299AG010).
20299AG010
BASE
• Used for replacing the bushing rear - front arm of front arm assembly.
• Used together with REMOVER (20299AG000).
20299AG020
STUD BOLT SOCKET
Used for removing and installing the stud bolt for front arm assembly installing portion.
20399AG000
STRUT MOUNT SOCKET
Used for disassembling and assembling strut mount.
—
SUBARU SELECT MONITOR 4
Used for setting of each function and troubleshooting for electrical system.
NOTE:
For detailed operation procedures of Subaru Select Monitor 4, refer to “Application help”.
2. GENERAL TOOL
TOOL NAME | REMARKS |
DST-i | Used together with Subaru Select Monitor 4. |
Alignment gauge adapter | Used for measuring wheel alignment. |
Turning radius gauge | Used for measuring wheel alignment. |
Toe-in gauge | Used for toe-in measurement. |
Tie-rod end puller | Used for disconnecting tie-rod end. |
Dial gauge | Used for damper strut measurement. |
Coil spring compressor | Used for strut assembly/disassembly. |
Component
FRONT SUSPENSION > General DescriptionCOMPONENT1. FRONT SUSPENSION(1)Front crossmember COMPL(14)Bushing rear - front arm(27)Clip(2)Flange bolt(15)Stud bolt (3)Front crossmember support(16)Stopper ...
Wheel alignment
...
Other materials:
Tongue load
Tongue load
Ensure that the trailer tongue load is from
8 to 11 percent of the total trailer weight
and does not exceed the maximum value
of 200 lbs (90 kg).
Jack
Bathroom scale
The tongue load can be weighed with a
bathroom scale as shown in the illustration
above. When weighing ...
Removal
COOLING(H4DO) > Radiator Main Fan and Fan MotorREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the reservoir tank. Reservoir Tank > REMOVAL">3. Disconnect the connector from the main fan motor assembly.4. Remove the bolts which hold the radiator main fan s ...
Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > CompressorREMOVAL1. CROSSTREK MODEL1. Perform compressor oil return operation. Compressor Oil > PROCEDURE">2. Turn the A/C switch to OFF, and turn the ignition switch to OFF.3. Using the refrigerant recovery system, discharge refrigerant. Re ...
