Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Phone volume settings

The call and ringtone volume can be adjusted. A ringtone can be selected.

1. Display the "PHONE" screen. Refer to "How to change the hands-free phone system" F5-73.

2. Touch the key.

3. Select the desired item to be set.

Options (volume settings) screen
Options (volume settings) screen

  1. Adjust the ringtone volume. The "−" key lowers the volume, and the "+" key increases the volume. (Default volume: 4 out of a total of 16 volume levels)
  2. Adjust the receive volume. The "−" key lowers the volume, and the "+" key increases the volume. (Default volume: 4 out of a total of 16 volume levels)
  3. Adjust the transmit volume. The "−" key lowers the volume, and the "+" key increases the volume. (Default volume: 3 out of a total of 5 volume levels)

NOTE

Phone settings
You can transfer the phonebook information and adjust the volume of your phone using the Bluetooth phone system. NOTE The ringer volume for outgoing and incoming calls, as well as the volume ...

Update contacts from phone
Operation methods differ between PBAP (Phone Book Access Profile) compatible and PBAP incompatible but OPP (Object Push Profile) compatible Bluetooth phones. 1. Display the "PHONE" screen. Refe ...

Other materials:

Dtc b1647 side satellite sensor bus lh lost communication
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1647 SIDE SATELLITE SENSOR BUS LH LOST COMMUNICATIONDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Open or short circuit in harness of side sensor bus (LH)• Side airbag sensor (L ...

Removal
DRIVE SHAFT SYSTEM > Rear AxleREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle, and then remove the rear wheels.3. Remove the axle nut.CAUTION:Do not loosen the axle nut while the rear axle is loaded. Doing so may damage the hub unit bearing.(1) Lift the c ...

Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Blower MotorREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Release the clips, and remove the under cover assembly - passenger.3. Remove the blower - motor.(1) Disconnect the connector.(2) Remove the screws and detach the blower - m ...

© 2016-2023 Copyright www.sucross.com