Subaru Crosstrek Service Manual: Operation

1. GENERAL DESCRIPTION

For on-board diagnosis function of the EyeSight, use the Subaru Select Monitor.

The on-board diagnosis function operates in three categories, which are used depending on the type of problems.

1. Diagnosis with diagnostic trouble code (DTC):

When the electrical failure occurs in the EyeSight, DTC is detected from the stereo camera. If the DTC is detected, the relevant DTC is displayed by illuminating or blinking the EyeSight warning light. To check the details concerning the DTC, use the Subaru Select Monitor.

2. Diagnosis with cancel code:

(1) This category of diagnosis requires actual driving of the vehicle in order to determine the cause in such a case when the set speed is cancelled during cruise control driving although cruise cancel condition is not entered.

(2) With ECM cancel code and stereo camera ACC cancel code, cancel condition (Code No.) is stored when detected during cruise control driving.

CAUTION:

• With ECM cancel code, not only the cruise control “cancel” occurred (although the driver does not input the “cancel” operation), but also the “cancel” condition input by the driver is stored.

• The latest memory contents of the ECM cancel code (latest code) is cleared when the ignition switch is turned to OFF. However, memory contents set by the diagnosis of faulty switches related to the system and cruise control will remain as trouble history (memory code) after the ignition switch is turned to OFF.

3. Real-time diagnosis:

Real-time diagnosis function is used to determine whether or not the input signal system is in good order, according to signal emitted from switches, sensors, etc.

(1) Vehicle cannot be driven at cruise speed when the problem occurs in the cruise control system or relevant circuits.

(2) Monitor the signal conditions from switches and sensors.

Inspection

Basic diagnostic procedure Procedure

Other materials:

Dtc u0402 invalid data received from tcm
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0402 INVALID DATA RECEIVED FROM TCMNOTE:For the diagnostic procedure, refer to LAN section. Basic Diagnostic Procedure">1. OUTLINE OF DIAGNOSISDetect malfunction of CAN communication.Judge as NG when ...

Rear towing hook
1. Take the towing hook and screwdriver out of the tool bucket. Take the jack handle out of the cargo area. 2. Pry off the cover on the rear bumper using a screwdriver, and you will find a threaded hole for attaching the towing hook. 3. Screw the towing hook into the thread hole unti ...

Dtc b16fa door sensor lh recognition error
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B16FA DOOR SENSOR LH RECOGNITION ERRORDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Front door impact sensor (LH) is misinstalled.• Airbag control module is faulty.CAUTION:Before ...