Subaru Crosstrek Service Manual: Installation
STARTING/CHARGING SYSTEMS(H4DO) > Starter
INSTALLATION
Install in the reverse order of removal.
NOTE:
• For CVT model, a nut is used at (a).
• Tighten the starter and cable stay (b) together using the upper bolt securing the starter.
Tightening torque:
T1: 14 N·m (1.4 kgf-m, 10.3 ft-lb)
T2: 50 N·m (5.1 kgf-m, 36.9 ft-lb)
Tightening torque:
10 N·m (1.0 kgf-m, 7.4 ft-lb)
Tightening torque:
3 N·m (0.3 kgf-m, 2.2 ft-lb)
Inspection
STARTING/CHARGING SYSTEMS(H4DO) > StarterINSPECTIONNOTE:• After the inspection, reinstall the disassembled or removed parts during the inspection in the reverse order of disassembly/removal p ...
Other materials:
Cruise control command switch
Installation
CRUISE CONTROL SYSTEM > Cruise Control Command SwitchINSTALLATIONCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">• Do no ...
Removal
SECURITY AND LOCKS > Rear Gate Latch and Actuator AssemblyREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear gate. Rear Gate Trim > REMOVAL">3. Remove the latch and actuator - rear gate.(1) Disconnect the connector.(2) Remove the bolts, ...
Operating conditions
The Reverse Automatic Braking (RAB) system in the Subaru Ascent is engineered
to function only when a specific set of operating conditions is satisfied. These
requirements ensure that the system delivers accurate detection and reliable braking
assistance while reversing.
EyeSight warni ...
