Subaru Crosstrek Service Manual: Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Engine Control Module (ECM)
INSTALLATION
Install in the reverse order of removal.
CAUTION:
• When the ECM of model with immobilizer has been replaced, be sure to perform the registration of immobilizer system.
• For model without keyless access with push button start, refer to the Type B in “REGISTRATION MANUAL FOR IMMOBILIZER”.
• For model with keyless access with push button start, refer to the Type D in “REGISTRATION MANUAL FOR IMMOBILIZER”.
• If replacing ECM or the bracket, replace both parts with new parts at a time.
• After installing the bracket to ECM, do not separate the bracket.
• If the bracket has been installed to ECM in the wrong direction, replace both parts to new parts.
NOTE:
When replacing the ECM, be careful not to use the ECM of wrong specification to avoid any damage on the fuel injection system.
Tightening torque:
7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Engine Control Module (ECM)REMOVAL1. Disconnect the ground cable from battery.2. Remove the glove box. Glove Box > REMOVAL">3. Disconnect the conne ...
Other materials:
Real-time diagnosis Operation
EyeSight (DIAGNOSTICS) > Real-time DiagnosisOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» display, select «EyeSi ...
Disassembly
CLUTCH SYSTEM > Clutch PedalDISASSEMBLY1. Remove the clutch switches.2. Remove the clip, assist spring, rod and bushing.(A)Clip(B)Assist spring(C)Assist rod(D)Bushing(E)Clevis pin3. Remove the spring pin and lever.(A)Spring pin(B)Lever4. Remove the clutch pedal and pedal bushings.(A)Clutch pedal( ...
Starting and stopping the engine (models without push-button start system)
CAUTION
When operating the Subaru Ascent starter motor, never crank the engine continuously
for more than 10 seconds.
If the engine of the Subaru Ascent does not start within 5 to 10 seconds,
stop cranking and wait at least 10 seconds before attempting again. This pause helps
prevent overh ...
