Subaru Crosstrek Service Manual: Installation
EXTERIOR/INTERIOR TRIM > Rear Gate Garnish
INSTALLATION
CAUTION:
Make sure that the harness grommet is securely installed.
If not properly installed, this may cause leaks.
Install each part in the reverse order of removal.
Tightening torque
Garnish assembly - rear gate: 4.5 N·m (0.46 kgf-m, 3.3 ft-lb)
Motor assembly - rear wiper: 6 N·m (0.61 kgf-m, 4.4 ft-lb)
Arm assembly - rear wiper: 8 N·m (0.82 kgf-m, 5.9 ft-lb)
Removal
EXTERIOR/INTERIOR TRIM > Rear Gate GarnishREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear gate. Rear Gate Trim > REMOVAL">3. Remove th ...
Other materials:
Engine compartment overview
Brake fluid reservoir
Fuse box
Windshield washer tank
Battery
Engine oil filler cap
Radiator cap
Engine coolant reservoir
Engine oil filter
Engine oil level gauge
Air cleaner case
The engine compartment of your Subaru Ascent is carefully organized to allow
easy acc ...
Dtc u0424 invalid data received from hvac control module
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0424 INVALID DATA RECEIVED FROM HVAC CONTROL MODULENOTE:Refer to “LAN SYSTEM (DIAGNOSTICS)” for diagnostic procedure. Basic Diagnostic Procedure">1. OUTLINE OF DIAGN ...
Installation
CLUTCH SYSTEM > FlywheelINSTALLATION1. Press in a new pilot bearing to the position where it is flush with the flywheel surface or up to 0.4 mm (0.016 in) deeper than that.CAUTION:Do not press the bearing inner ring.(A)Pilot bearing2. Temporarily tighten the crankshaft position sensor plate and f ...
