Subaru Crosstrek Service Manual: Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Secondary Pressure Sensor
INSTALLATION
CAUTION:
• Be sure to prevent water or oil from contacting the connector terminal of secondary pressure sensor. If adhesion occurs, replace with a new part.
• After installing the secondary pressure sensor, adjust the CVTF level.
Install in the reverse order of removal.
NOTE:
Use new O-rings.
Tightening torque:
39 N·m (4.0 kgf-m, 28.8 ft-lb)
Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Secondary Pressure SensorREMOVALCAUTION:• Be sure to prevent water or oil from contacting the connector terminal of secondary pressure sensor. If a ...
Other materials:
Location
ENTERTAINMENT > Relay and FuseLOCATIONRelay & fuse boxFuse 20 A (rear accessory power supply socket)(A)Fuse 10 A (front accessory power supply socket)(B)Fuse 10 A (audio, navigation unit, AUX input terminal, data communication module*1)(C)Fuse 15 A (data communication module*1)(D)*1: Model wi ...
SRS airbag system warning light
WARNING
If the SRS airbag system warning light in your Subaru Ascent shows any abnormal
behavior, immediately stop the vehicle in a safe location and contact an authorized
SUBARU dealer for inspection. Failure to properly diagnose and repair the system
may result in the seatbelt pretensioners ...
Inspection
SECURITY AND LOCKS > Rear Gate Latch and Actuator AssemblyINSPECTION1. LATCHCheck if the latch operates normally.If latch deformation, abnormal wear, or unsmooth lock operation is observed, replace the latch and actuator - rear gate.2. ACTUATORPreparation tool:Circuit tester1. Check door lock ope ...
