Subaru Crosstrek Service Manual: Installation

1. Temporarily install the drive plate and reinforcement drive plate.

NOTE:

Align the knock pin hole of the crankshaft position sensor plate to the knock pin of the crankshaft to secure the knock pin.

2. Set the ST.

3. Tighten the drive plate mounting bolt in two stages.

(1) Tighten the drive plate mounting bolt.

Tightening torque:

30 N·m (3.1 kgf-m, 22.1 ft-lb)

(2) While checking the tightening angle with the angle gauge, tighten the drive plate mounting bolts to the specified angle.

Tightening angle:

30° — 35°

4. Install the transmission assembly to the vehicle. Automatic Transmission Assembly > INSTALLATION">

Removal

Extension case

Other materials:

Removal
LIGHTING SYSTEM > Ignition Switch IlluminationREMOVALNOTE:The ignition switch illumination is integrated into the immobilizer antenna assembly.1. Disconnect the ground cable from battery. NOTE">2. Remove the cover assembly - column.(1) Remove the screws by turning the steering wheel to r ...

List
ENTERTAINMENT > Diagnostics with PhenomenonLIST1. AUDIO SYSTEMSymptomsReferencePower will not turn ON. Diagnostics with Phenomenon > INSPECTION">The screen freezes and does not accept any operation entry. Diagnostics with Phenomenon > INSPECTION">The screen is blacked out, o ...

Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Front Oxygen (A/F) SensorINSTALLATIONCAUTION:If lubricant is spilt over the exhaust pipe, wipe it off with cloth to avoid emission of smoke or causing a fire.1. Before installing front oxygen (A/F) sensor, apply anti-seize compound only to the threaded portio ...