Subaru Crosstrek Service Manual: Installation
BRAKE > Front Disc Rotor
INSTALLATION
NOTE:
Before installation, remove mud and foreign matter from the caliper body assembly.
1. Before installation, check the front disc rotor. Front Disc Rotor > INSPECTION">
2. Install each part in the reverse order of removal.
Tightening torque:
Brake hose bracket: 33 N·m (3.36 kgf-m, 24.3 ft-lb)
Mounting bolt: Refer to “COMPONENT” of “General Description” for the tightening torque. General Description > COMPONENT">
Front wheel: Except for C4 model
120 N·m (12.24 kgf-m, 88.5 ft-lb)
Front wheel: C4 model
100 N·m (10.20 kgf-m, 73.8 ft-lb)
Removal
BRAKE > Front Disc RotorREMOVAL1. Lift up the vehicle, and then remove the front wheels.2. Remove the caliper body assembly from the housing assembly - front axle.(1) Remove the bolt from the brake ...
Other materials:
Installation
STARTING/CHARGING SYSTEMS(H4DO) > StarterINSTALLATIONInstall in the reverse order of removal.NOTE:• For CVT model, a nut is used at (a).• Tighten the starter and cable stay (b) together using the upper bolt securing the starter.Tightening torque:T1: 14 N·m (1.4 kgf-m, 10.3 ft-l ...
Installation
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > CompressorINSTALLATIONCAUTION:• Replace the O-rings on the hose - pressure suction and discharge with new parts, and then apply compressor oil.• After replacing the compressor assembly, adjust the amount of the compressor oil. Compressor Oil ...
Removal
SECURITY AND LOCKS > Rear Gate Opener ButtonREMOVALNOTE:• The button - opener rear gate is integrated with the rear lock button. (Model with keyless access with push button start)• Open the panel - rear gate before disconnecting the ground terminal from the battery.1. Disconnect the g ...
