Subaru Crosstrek Service Manual: Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Ambient Sensor
INSPECTION
1. Visually check the ambient sensor for dirt or damage, and clean or replace as necessary.
2. Check the resistance between ambient sensor terminals.
CAUTION:
During inspection, be careful not to touch the sensor end in order to avoid misjudgment due to body temperature.
Preparation tool:
Circuit tester
Terminal No. | Inspection conditions | Standard |
1 — 2 | 10°C | 5.82 — 6.18 k? |
15°C | 4.58 — 4.87 k? | |
20°C | 3.64 — 3.86 k? | |
25°C | 2.91 — 3.09 k? | |
30°C | 2.35 — 2.49 k? | |
35°C | 1.9 — 2.02 k? | |
40°C | 1.56 — 1.65 k? | |
45°C | 1.28 — 1.36 k? | |
50°C | 1.06 — 1.12 k? | |
55°C | 0.88 — 0.93 k? | |
60°C | 0.74 — 0.78 k? |
3. Replace the ambient sensor if the inspection result is not within the standard value.
Ambient sensor
...
Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Ambient SensorREMOVAL1. Disconnect the ground cable from battery. Battery > REMOVAL">2. Remove the ambient sensor.(1) Disconnect the connector ...
Other materials:
Removal
SECURITY AND LOCKS > IG Relay1 (Push Button Start)REMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Disconnect the ground cable from battery ...
Locking and unlocking from the outside
NOTE
If you unlock the driver's door with a
key (including a mechanical key) and
open the door while the alarm system
is armed, the alarm system is triggered
and the vehicle's horn sounds. In this
case, perform any of the following
operations:
Models with "keyless access with
push-button st ...
Inspection
PERIODIC MAINTENANCE SERVICES > Engine CoolantINSPECTIONCAUTION:• Do not use water instead of coolant.• Refer to “RM” section for the recommended engine coolant. 1. Park the vehicle on a level surface.2. Make sure the engine coolant level in the reservoir tank is between & ...
