Subaru Crosstrek Service Manual: Ambient sensor

Installation

HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Air Vent GrilleINSTALLATIONCAUTION:After installing the center grille assembly or grille assembly - ventilation, check that the air vent grille is inserte ...

Inspection

HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Ambient SensorINSPECTION1. Visually check the ambient sensor for dirt or damage, and clean or replace as necessary.2. Check the resistance between ambient ...

Other materials:

Installation
VEHICLE DYNAMICS CONTROL (VDC) > Rear ABS Wheel Speed SensorINSTALLATIONCAUTION:Be careful not to damage the sensor.1. Install each part in the reverse order of removal.2. Route the rear ABS wheel speed sensor cable to the upper arm assembly.NOTE:Check the identification (mark) on the harness to ...

To decrease the speed (by the "RES/SET" switch)
Press the "RES/SET" switch to the "SET" side and hold it until the vehicle reaches the desired speed. Then, release the switch. The vehicle speed at that moment will be memorized and treated as the new set speed. U.S.-spec. models When the difference between the actual vehicle speed and ...

Engine lubrication system trouble in general Inspection
LUBRICATION(H4DO) > Engine Lubrication System Trouble in GeneralINSPECTIONBefore performing diagnostics, make sure that the engine oil level is correct and no oil leakage exists.TroublePossible causeCorrective actionWarning light remains ON.a. Oil pressure switch failure Cracked diaphragm or ...