Subaru Crosstrek Service Manual: Inspection
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > General Description
INSPECTION
1. BATTERY
Check the battery. Battery > INSPECTION">
2. TRANSMISSION GROUND
Make sure that the ground terminal bolt is tightened securely.
Tightening torque:
14 N·m (1.4 kgf-m, 10.3 ft-lb)
3. OPERATION OF SHIFT SELECT LEVER
Make sure there is no noise, dragging or contact pattern in each select lever range.
WARNING:
Stop the engine while checking operation of the select lever.
Preparation tool
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each fu ...
Learning control
...
Other materials:
Removal
EXTERIOR/INTERIOR TRIM > Rear Quarter TrimREMOVAL1. CROSSTREK MODELCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">• Airbag system sat ...
Removal
SECURITY AND LOCKS > Keyless Access Outdoor AntennaREMOVAL1. FRONT ANTENNACAUTION:Do not remove the antenna from the front door outer handle.If replacement is needed, replace the front outer handle assembly as a set.Remove the handle - door outer. Front Outer Handle > REMOVAL">2. REAR ...
Procedure
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > AWD ON/OFF Switching ModePROCEDURECAUTION:• Do not turn the power of the Subaru Select Monitor OFF during work, and do not disconnect the data link connector.• On completing the work in FWD, switch back in AWD.1. Shift the select lever to &l ...
