CautionSafety precautions
WARNING
Bulbs may become very hot while
illuminated. Before replacing
bulbs, turn off the lights and wait
until the bulbs cool down. Otherwise,
there is a risk of sustaining
a burn injury.
For models with HID low beam
headlights, observe the following
precautions. Not doing so carries
the ...
Inspection
CLUTCH SYSTEM > FlywheelINSPECTIONCAUTION:Because the center pilot bearing is grease-sealed and is a non-lubrication type, do not wash with gasoline or solvents.1. If there is damage or defectiveness in the facing sliding surface or ring gear, replace the flywheel.(A)Flywheel(B)Ring gear2. Smooth ...
Disassembly
DRIVE SHAFT SYSTEM > Rear Drive ShaftDISASSEMBLY1. Remove the outer race (DOJ) from the shaft assembly.CAUTION:Be careful not to damage the boot.(1) Using a flat tip screwdriver or pliers, loosen the boot band on the large end of boot (DOJ).CAUTION:Be careful not to damage the boot.(2) Remove the ...