Subaru Crosstrek Service Manual: General description
Installation
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > FRESH/RECIRC Door ActuatorINSTALLATIONCAUTION:• After installing the grille assembly - ventilation RH, check that the air vent grille of the grille ...
Caution
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > General DescriptionCAUTION• Before disassembling or reassembling parts, always disconnect the battery ground cable from battery. When replacing the ...
Other materials:
Canceling the function for meter/gauge needle movement upon turning on the
ignition switch
It is possible to activate or deactivate the
movement of the meter needles and
gauge needles that takes place when the
ignition switch is turned to the "ON"
position.
Type A combination meter
To change the setting, perform the following
procedure.
1. Turn the ignition switch to the "LOCK"/ ...
Average fuel consumption
U.S.-spec. models
Except U.S.-spec. models
This display shows the average rate of
fuel consumption since the trip meter was
last reset.
Trip knob
Pressing the trip knob toggles the display
between the average fuel consumption
corresponding to the A trip meter display
and ...
Installation
CONTROL SYSTEMS > Select CableINSTALLATION1. Position the select cable as shown in the figure, and install it to the plate assembly.CAUTION:• If the cable is installed in the wrong direction, loosen the bracket bolts, and then reinstall the cable in the correct direction.• Do not adju ...
