Subaru Crosstrek Service Manual: Front bumper

Removal

EXTERIOR/INTERIOR TRIM > Floor Under ProtectorREMOVAL1. Lift up the vehicle.NOTE:A plate type lift cannot be used.2. Remove the bolts and clips, and remove the floor under protector. ...

Installation

EXTERIOR/INTERIOR TRIM > Front BumperINSTALLATION1. Install each part in the reverse order of removal.2. Secure the flange section of the bumper face - front to the bracket - front bumper side.CAUT ...

Other materials:

Inspection
SECURITY AND LOCKS > Rear Gate Latch and Actuator AssemblyINSPECTION1. LATCHCheck if the latch operates normally.If latch deformation, abnormal wear, or unsmooth lock operation is observed, replace the latch and actuator - rear gate.2. ACTUATORPreparation tool:Circuit tester1. Check door lock ope ...

Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Tumble Generator Valve AssemblyINSPECTION1. CHECK MOTOR1. Connect the battery positive terminal to terminal No. 5 and the battery ground terminal to terminal No. 4, and check that the valve is fully opened on LH side and the valve is fully closed on RH side.C ...

Electrical specification
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATIONCAUTION:Never remove the occupant detection control module, occupant detection sensor or seat frame because they are integrated into one unit.Terminal No.Terminal nameInput/Output valueNote1Airbag CM commun ...