Subaru Crosstrek Service Manual: Dtc u0122 lost communication with vehicle dynamics control module

Subaru Crosstrek Service Manual / Engine (diagnostics)(h4do) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc u0122 lost communication with vehicle dynamics control module

ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)

DTC U0122 LOST COMMUNICATION WITH VEHICLE DYNAMICS CONTROL MODULE

NOTE:

For the diagnostic procedure, refer to LAN section. Basic Diagnostic Procedure">

1. OUTLINE OF DIAGNOSIS

Detect malfunction of CAN communication.

Judge as NG when CAN communication failure between TCM, VDC CM and combination meter has occurred.

2. COMPONENT DESCRIPTION

(Common Specifications)

CAN Protocol 2.0 B (Active)

Frame Format: 11 Bit ID Frame (Standard Frame)

Conforms to ISO11898

Communication Speed: 500 kbps

3. EXECUTION CONDITION

Secondary Parameters	Execution condition
Battery voltage	≥ 10.9 V

4. GENERAL DRIVING CYCLE

Perform the diagnosis continuously after starting the engine.

5. DIAGNOSTIC METHOD

Judge as NG when the following conditions are established.

Judgment Value

Malfunction Criteria	Threshold Value
CAN data from vehicle dynamics control module	= Lost

Time Needed for Diagnosis: 500 ms

Malfunction Indicator Light Illumination: Illuminates as soon as a malfunction occurs.

Dtc p0560 system voltage

ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0560 SYSTEM VOLTAGEDTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replac ...

Dtc p000a "a" camshaft position slow response bank 1

ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P000A "A" CAMSHAFT POSITION SLOW RESPONSE BANK 1NOTE:For the diagnostic procedure, refer to DTC P00 ...

Other materials:

Inspection mode Operation
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Inspection ModeOPERATIONIt is possible to diagnose the DTC by performing the indicated inspection mode. After correcting the DTC, perform a necessary inspection mode and make sure that the function is resumed correctly and the DTC is r ...

Removal
EXTERIOR/INTERIOR TRIM > Lower Inner TrimREMOVALCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">• Airbag system satellite safing senso ...

By incoming calls
On the phone (menu) screen, select the "Incoming Calls" key to open the "Incoming Calls" screen. You can make a call by selecting an item in the incoming call history list. If there is no incoming call history, a message appears to indicate that there is no incoming call history data. ...