Subaru Crosstrek Service Manual: Dtc p000a "a" camshaft position slow response bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC P000A "A" CAMSHAFT POSITION SLOW RESPONSE BANK 1
NOTE:
For the diagnostic procedure, refer to DTC P0011. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0011 "A" CAMSHAFT POSITION - TIMING OVER-ADVANCED OR SYSTEM PERFORMANCE BANK 1">
1. OUTLINE OF DIAGNOSIS
Detect the AVCS system malfunction.
Judge NG when the amount of AVCS actual timing advance does not approach to the amount of AVCS target timing advance.
2. EXECUTION CONDITION
Secondary parameters | Execution condition |
Battery voltage | ≥ 10.9 V |
AVCS control | In operation |
|Target timing advance change amount (per 64 ms)| | < 3.2 °CA |
3. GENERAL DRIVING CYCLE
Perform the diagnosis continuously when the engine speed increases and AVCS operates.
4. DIAGNOSTIC METHOD
When the differences of target timing advance amount and actual timing advance amount is calculated during AVCS control, and the difference per predetermined time is the specified value or larger.
Judge as NG when the following conditions are established within the predetermined time.
Malfunction Criteria | Threshold Value |
Σ|(Target position − Actual position)| | > 4000 °CA (Bank 1) > 4000 °CA (Bank 2) |
Time needed for diagnosis: Less than 1 second
Malfunction indicator light illumination: Illuminates when malfunction occurs in 2 continuous driving cycles.
Dtc u0122 lost communication with vehicle dynamics control module
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0122 LOST COMMUNICATION WITH VEHICLE DYNAMICS CONTROL MODULENOTE:For the diagnostic procedure, refer to LAN ...
Dtc p000b "b" camshaft position slow response bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P000B "B" CAMSHAFT POSITION SLOW RESPONSE BANK 1NOTE:For the diagnostic procedure, refer to DTC P00 ...
Other materials:
Precautions when working with the parts mounted on the vehicle
WIRING SYSTEM > Working PrecautionsPRECAUTIONS WHEN WORKING WITH THE PARTS MOUNTED ON THE VEHICLE1. When working under a vehicle which is jacked-up, always be sure to use rigid rack.2. The parking brake must always be applied during working. Also, in automatic transmission vehicles, keep the sele ...
Refrigerant charging procedure Procedure
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Refrigerant Charging ProcedurePROCEDURECAUTION:• While working, be sure to wear protective goggles and protective gloves.• Air in the cycle can cause insufficient air conditioning, and water in the cycle can cause clogging in the cycle (icing ...
Disassembly
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Leak Check Valve AssemblyDISASSEMBLY1. Remove the drain separator from the leak check valve assembly. Drain Separator > REMOVAL">2. Disconnect the drain tube from the leak check valve assembly.NOTE:Disconnect the quick connector ...
