KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC B1576 EGI CONTROL MODULE EEPROM
DTC detecting condition:
• ECM malfunctioning
• When the ROM in ECM was inaccessible during registration.
| STEP | CHECK | YES | NO |
1.PERFORM ECM REGISTRATION.
Perform ECM registration. Refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.
Is ECM registration complete?
Make sure that the engine can start. This completes the work.
Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1576 EGI CONTROL MODULE EEPROM">Go to Step 2.
2.PERFORM ECM REGISTRATION.
Perform ECM registration. Refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.
Is ECM registration complete?
Make sure that the engine can start. This completes the work.
Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1576 EGI CONTROL MODULE EEPROM">Go to Step 3.
3.PERFORM ECM REGISTRATION.
Perform ECM registration. Refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.
Is ECM registration complete?
Make sure that the engine can start. This completes the work.
Replace the ECM. Engine Control Module (ECM) > REMOVAL">
Dtc b1572 imm circuit except antenna circuit
Dtc b1577 imm control module eepromNew vehicle break-in driving - the first 1,000 miles (1,600 km)
The performance and long life of your
vehicle are dependent on how you handle
and care for your vehicle while it is new.
Follow these instructions during the first
1,000 miles (1,600 km):
Do not race the engine. And do not
allow engine speed to exceed 4,000 rpm
except in an emergency
...
Light control and wiper control levers/switches
Windshield wiper
Mist
Windshield washer
Rear window wiper and washer switch
Wiper intermittent time control switch
Wiper control lever
Light control switch
Fog light switch
Headlight ON/OFF/AUTO
Headlight flasher High/Low beam
Turn signal lever
...
Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > CVTF Cooler (With Warmer Function)INSPECTIONReplace any faulty CVTF cooler hoses, CVTF cooler pipes and clamps found in the inspection below.1. Check that there are no CVTF or engine coolant leaks from the connections.2. Check the clamp for deformation. ...