It is unnecessary to check the deflection of the drive belt periodically because your engine is equipped with an automatic belt tension adjuster. However, replacement of the belt should be done according to the maintenance schedule in the "Warranty and Maintenance Booklet". Consult your SUBARU dealer for replacement.
If the drive belt is loose, cracked or worn, contact your SUBARU dealer.
Spark plugs
Manual transmission oilRemoval
MECHANICAL(H4DO) > Timing Chain AssemblyREMOVAL1. TIMING CHAIN RHNOTE:When replacing a single part, perform the work with the engine assembly installed to body.1. Remove the chain cover. Chain Cover > REMOVAL">2. Using ST and by turning the crankshaft, align the alignment marks of cra ...
Removal
DRIVE SHAFT SYSTEM > Rear Drive ShaftREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle, and then remove the rear wheels.3. Remove the axle nut.CAUTION:Do not loosen the axle nut while the rear axle is loaded. Doing so may damage the hub unit bearing.(1) Lif ...
Removal
WIPER AND WASHER SYSTEMS > Washer Tank and MotorREMOVAL1. WASHER TANK1. Open the hood COMPL - front.2. Disconnect the ground cable from battery. NOTE">3. Remove the bumper face - front. Front Bumper > REMOVAL">4. Remove the tank - washer assembly.(1) Remove the clip of the ho ...